Step 1: Power supply voltage 220V connection
Step 2: Fix the small table
Step Three: Posting
From the dead point (or starting point) of the cylinder, the plate is pasted according to the length of the printed bag and the customer's requirements (the starting point is the position marked with a black marker on the drum), the cylinder is rotated forward, and the plate is pasted.
Step 4: Add ink
The ink in the ink cartridge must exceed the rubber roller. If the ink is lacking, it will cause damage to the rubber roller (green rubber roller)
the fifth step:
The upper part of both sides of the screen roller is pressed down slowly with the handles to make the screen roller ink uniform, but the pressure cannot be too large.
The pressure on the imprint shaft and the uneven printing can be adjusted appropriately. The screw and pressure on the upper part of the cylinder can be adjusted.
Feeding is to send the woven bag to the position of the bottom of the lower roller.
Step 8: Turn on the power switch first,-adjust the speed-the imprint is on, the lower is off. The imprint must be turned on first during work, and the speed is adjusted manually.